Filter
Top Products
Front panel LEDs Includes front panel LEDs to indicate line / battery power status, over / under voltage correction, battery charge level,
load percentage, overload, wiring fault and replace battery.
Alarms Audible alarm warns of power failure condition
Switches Includes two pushbutton switches for on/off power control and self-test/ alarm cancel functions. Also includes two
dipswitch controls for setting the nominal voltage
SURGE / NOISE SUPPRESSION
AC surge
suppression
570 joules
AC suppression
response time
Instantaneous
Dataline suppression Includes 8-wire RJ45 jack; pins 1, 2, 3 and 6 provide 10baseT Ethernet line surge suppression with 7.5V clamping; pins
4 and 5 provide single-line tel/DSL line surge suppression starting at 260V
EMI / RFI AC noise
suppression
Yes
PHYSICAL
Shipping weight (lbs) 37
Shipping weight (kg) 16.8
Shipping Dimensions
(HWD/in)
13 x 10 x 23.75
Shipping Dimensions
(HWD/cm)
33 x 25.4 x 60.3
Unit weight (lbs) 33.9
Unit weight (kg) 15.4
Unit Dimensions
(HWD/in)
10.1 x 6.7 x 13.8
Unit Dimensions
(HWD/cm)
25.7 x 16.9 x 35.1
Material of
construction
Steel
Form factors
supported
Tower
Cooling method Fan
Battery Access Supports battery access and hot-swap replacement without powering connected equipment off
ENVIRONMENTAL
Relative Humidity 0 to 95%, non-condensing
COMMUNICATIONS
Network monitoring
port
Includes 2 built-in monitoring ports, 1 USB and 1 DB9. Each supports on battery, low battery, power restored, AC line
voltage, DC battery voltage, load percentage, battery charge current, battery capacity and line frequency status
messaging.
Software and cabling
included
Includes PowerAlert UPS monitoring software for all common network and stand-alone operating systems. Ships with 2
cables, 1 USB and 1 DB9
SNMP compatibility SNMP adapter accessory # SNMPWEBCARD
WatchDog
compatibility
Compatible with Tripp Lite's WatchDog Software to restore operation to locked equipment through soft reboot of
application/OS or hard power off/on reboot of connected equipment; ideal for unattended kiosk applications
LINE / BATTERY TRANSFER
Transfer time from
line power to battery
mode
4 milliseconds (typical)
Low voltage transfer
to battery power
Switches to battery power as line voltage decreases to 95V (120V), 87V (110V) , or 83V (100V) or less. Resets back to
line power mode as line voltage increases to 100V (120V), 92V (110V), or 87V (100V) or higher