Filter
Top Products
12
Battery Replacement
Model SMX500RT1U SMX750RT1U SMX1000RT2U SMX1500XLRT2U SMX3000XLRT2U
Series # AGSMX500RT1U AGSM751SRM1U AGSM4724 AGSM152DRTI2U AGSM4878
Input
Nominal Voltage/Frequency: 230VAC, 50/60Hz 230VAC, 50/60Hz 230VAC, 50/60Hz 230VAC, 50/60Hz 230VAC, 50/60Hz
Suggested Circuit: 10 amp 10 amp 10 amp 10 amp 20 amp
Output
Capacity (VA/Watts) 500/300 750/450 1000/700 1500/1000 3000/2250
On Line Nominal Voltage/Waveform: 230VAC/sine wave 230VAC/sine wave 230VAC/sine wave 230VAC/sine wave 230VAC/sine wave
On Battery Nominal Voltage/Waveform: 230VAC/PWM sine wave 230VAC/sine wave 230VAC/sine wave 230VAC/sine wave 230VAC/sine wave
Battery Recharge Time (to 90% charge) 2-4 hrs. 2-4 hrs. 2-4 hrs. 2-4 hrs. 2-4 hrs.
Typical Transfer Time 2-4 ms. 2-4 ms. 2-4 ms. 2-4 ms. 2-4 ms.
Approvals: CE, GOST, SASO,IRAM CE, GOST, SASO,IRAM CE, GOST, SASO, IRAM CE, GOST, SASO, IRAM CE, GOST, SASO, IRAM
ALL MODELS:Voltage-Regulated Output Voltage Range (230V +/- 9%); On Battery Output Voltage Range (230V +/- 5%); AC Surge Suppression (exceeds IEEE 587
Cat. A& B standards); AC Noise Attenuation (>40 dB); AC Protection Modes (H to N).
The policy of Tripp Lite is one of continuous improvement. Specifications are subject to change without notice.
Note on Labeling
Two symbols are used on the label.
V~ : AC Voltage
V : DC Voltage
Specifications
Under normal conditions, the original batteries in your UPS will last many years. See Safety section
before replacing batteries. The batteries are designed for hot-swap replacement (i.e. leaving the UPS in
ON mode), but qualified service personnel may wish to put the UPS in the OFF mode before proceeding.
1U UPS Models
Procedure
Remove Front
Panel
Disconnect
Batteries
Remove/Dispose of
Batteries
Add Batteries
Connect Batteries
Attach connectors: black-
to-black and red-to-red.
Replace Front Panel
6
5
4
3
2
1
2U UPS Models
T
P
RO
®
UPS
1
6
2
5
3
4
S
MART
P
RO
®
UPS
1
6
2
5
3
4
200407003 93-2259 SMARTPROINT Owners Manual.qxd 7/30/2004 11:56 AM Page 12