Filter
Top Products
5
Other UPS Features
AC Receptacles
The receptacles provide your connected equipment with AC line
power during normal operation. They will provide battery power
during blackouts and brownouts only if the “OFF/ON” Switch is set
to the “ON” position. The receptacles also protect your equipment
against damaging surges and line noise. Select models, however,
feature “surge-only” receptacles (identified on the back of your
UPS) that provide peripherals with surge protection without com-
mitting precious battery power to support them during blackouts.
DB9 Port (Available on select models)
The DB9 port connects your UPS to any workstation or server. Use
with Tripp Lite software and cabling to automatically save open
files and shut down equipment during a blackout. This port sends
contact-closure signals to indicate
line-fail and low-battery sta-
tus. It also receives a shut down signal from the connected
computer to conserve the UPS battery charge. Contact Tripp Lite
Customer Support for more information.
Indicator Lights
All Indicator Light descriptions apply when the UPS is plugged into a
wall outlet and turned ON.
This green light will turn ON whenever your UPS is plugged in and
receiving normal AC line power.
This red light will turn ON when your UPS is providing your
equipment with battery power.
This yellow light will turn ON after you test your UPS battery’s
charge with the “Mute/Test” Switch to indicate that the UPS’s
battery is less than fully charged. If it stays on continuously,
contact Tripp Lite for service. The light will flash after you set the
“OFF/ON” Switch to the “OFF” position to indicate that the UPS will
not provide battery backup during a blackout or brownout.
This red light will turn ON when the UPS’s capacity has been
exceeded while it is operating from battery power (either during a
self-test or during a blackout). Remove overload from battery-
supported outlets immediately.
Available on
select models