Tripp Lite TLP606USB Surge Protector User Manual


 
2
SAVE THESE INSTRUCTIONS
CAUTION! DO NOT connect to an ungrounded outlet. DO NOT use with 2-wire extension cords or
adapters. This surge suppressor is designed for indoor use only. Install the surge suppressor away
from heat-emitting appliances such as radiators or heat registers. Do not install where excessive
moisture is present. Do not plug extension cords into it. Never install electrical, telephone, network
or coaxial wiring during a lightning storm. Do not drill into any part of the housing or open the
housing for any reason. There are no user-serviceable parts inside.
Important Safety Instructions
• Use of this equipment in life support applications where failure of this equipment can reasonably
be expected to cause the failure of the life support equipment or to significantly affect its safety
or effectiveness is not recommended. Do not use this equipment in the presence of a
flammable anesthetic mixture with air, oxygen or nitrous oxide.
Installation
Mount Your Surge Suppressor
(Optional Installation, TLP606USB Only): If desired, mount your surge suppressor on a wall
or other sturdy, vertical surface. However, you must mount the surge suppressor prior to
connecting your equipment. Place a sheet of paper over the surge suppressor’s mounting holes
and mark their centers with a push pin. Next, place this template over the desired area and mark
with the push pins. Install screws (user supplied) into the marks until ¼ in. (0.6 cm) of the screw
heads are exposed. Mount the surge suppressor over the screw heads and slide into place.
(Installation, TLP606DMUSB
Only): This suppressor features a
built-in clamping system for
attaching the unit to desks,
tables and work benches. To
install, loosen the two mounting
clamps, then slide the suppressor
firmly onto the edge of an
appropriate surface. Retighten
the mounting clamps.
Connect Your Surge Suppressor to
the AC Power Line: Plug the surge
suppressor’s power cord into a
standard, 3-wire grounded 120V AC
outlet.
Turn Your Surge Suppressor ON:
Press the surge suppressor’s power
switch to “ON” or “RESET” (depending
on model). Select models feature an
illuminated switch.
Installation, TLP606DMUSB Only
13-05-274 93-32C0-EN.indd 2 6/14/2013 9:50:49 AM