Filter
Top Products
7R
Mounting
WARNING! Mount your Inverter BEFORE DC battery and AC power
connection. Failure to follow these instructions may lead to personal injury
and/or damage to the Inverter and connected systems.
Tripp Lite recommends permanent mounting of your Inverter. User must supply mounting hardware and is responsible for determining if
the hardware and mounting surface are suitable to support the weight of the Inverter. Contact Tripp Lite if you require further assistance in
mounting your Inverter.
Vehicular and Non-Vehicular Mounting
(2012 model only)
• Horizontal Mount • Vertical Mount
Whether mounted horizontally or vertically, the Inverter must be
located in an enclosed compartment, shielded from outside weather
conditions.
Using the measurements from the diagram, install two user-supplied ¼" (6
mm) fasteners into a rigid horizontal surface, leaving the heads slightly
raised. Slide the Inverter forward over the fasteners to engage the mount-
ing feet molded on the front of the Inverter cabinet. Install and tighten addi-
tional user-supplied ¼" (6 mm) fasteners into the mounting feet molded on
the rear and sides of the Inverter cabinet. The rear feet extend beyond the
unit’s cabinet to provide for adequate ventilation space behind the cooling
fan(s); they should not be removed. The polycarbonate cabinet and mount-
ing feet of your Utility/Work Truck Inverter are durable enough to allow
for vertical mounting as well, if your vehicle compartment requires this
configuration. For vertical mounting, the control panel of the Inverter
should face up.
5.87 in.
(14.91 cm.)
1.64 in.
(4.15 cm.)
5.87 in.
(14.91 cm.
)
5.57 in.
(14.16 cm.)
5.57 in.
(14.16 cm.)
9.59 in.
(24.35 cm.)
9.59 in.
(24.35 cm.)
A
B
▼
A
B
Vehicular and Non-Vehicular Mounting
(750 & 1250 models only)
• Horizontal Mount • Vertical Mount
Whether mounted horizontally or vertically, the Inverter must be
located in an enclosed compartment, shielded from outside weather
conditions.
Using the measurements from the diagram, install two user-supplied ¼"
(6 mm) fasteners into a rigid horizontal surface, leaving the heads slightly
raised. Slide the Inverter/Charger back over the fasteners to engage the
mounting slots molded on the bottom of the Inverter/Charger cabinet.
Install and tighten two user-supplied ¼" (6 mm) fasteners into the
mounting feet molded on the front of the Inverter/Charger cabinet. The
polycarbonate cabinet and mounting feet of your Utility/Work Truck
Inverter are durable enough to allow for vertical mounting as well, if your
vehicle compartment requires this configuration. For vertical mounting,
the control panel of the Inverter should face up.
6.75 in.
(17.1 cm)
7.87 in.
(20 cm)
6.75 in.
(17.1 cm)
4.5 in.
(11.4 cm)
A
B
C
A
B
▼
C
200502084.qxd 3/7/2005 7:24 PM Page 7