Filter
Top Products
Font Card Installation Guide
Document #50-70409-001 Rev. A Page 2 of 5
Hewlett-Packard 2420 / 2430 Printers:
IMPORTANT: Ensure the printer power is switched OFF, and then
disconnect the printer power cord from the AC wall outlet.
1. Unsnap and slide the right-side panel toward the rear of the printer (Figure 1).
2. Open the electronics access door (Figure 2). The metal door can easily be
removed by lifting the door off the hinge slots.
Figure 1 Figure 2
3. Insert the font card into the right-hand (slot #2) memory card slot as shown (Figure 3). The font card cannot
be used in the left-hand slot. Ensure the font card is fully inserted and seated against the connector so that
none of the contact pins are visible (Figure 4).
Figure 3 Figure 4
4. Replace the printer panels, and then reconnect the printer power cord and printer data cable.
5. Refer to the TROY Quick-Start Guide (provided with your TROY Font Card Solution) for instructions on
installing the required TROY software and support files.
NOTE: If assistance is required for installing the font card, please call TROY Technical Support
at (800) 332-6427. Customers outside the United States, please call (304) 232-0899.