Filter
Top Products
Font Card Installation Guide
Document #50-70409-001 Rev. A Page 4 of 5
Hewlett-Packard 9050 Series Printers:
IMPORTANT: Ensure the printer power is switched OFF, and then
disconnect the printer power cord from the AC wall outlet.
1. Loosen the two thumbscrews (turn counter-clockwise) at the rear of the printer
(Figure 1 and Figure 2), and then carefully slide the formatter board out of the
printer (Figure 3).
Figure 1 Figure 2 Figure 3
2. Set the formatter board on a clean flat surface (Figure 4). Insert the font card into card slot #2 (center card
slot) as shown (Figure 5). The font card cannot be used in card slot #1. Do not remove or change the slot
positions of any existing cards. Ensure the font card is fully inserted and seated against the connector.
Figure 4 Figure 5
Carefully slide the
formatter board
out of the printer.
Insert font card
into slot #2 only.
1
2
3