Filter
Top Products
20
3.6 Setting Ethernet by Diagnostic Utility
The Diagnostic Utility is enclosed in the CD disk \Utilities directory. Users can use Diagnostic
Tool to setup the Ethernet by RS-232, USB and Ethernet interfaces. The following contents
will instruct users how to configure the Ethernet by these three interfaces.
3.6.1 Using USB interface to setup Ethernet interface
1. Connect the USB cable between the computer and the printer.
2. Turn on the printer power.
3. Start the Diagnostic Utility by double clicking on the icon.
Note: This utility works with printer firmware V6.00 and
later versions.
4. The Diagnostic Utility default interface setting is USB interface. If USB interface is
connected with printer, no other settings need to be changed in the interface field.
5. Click on the “Ethernet Setup” button from “Printer Function” group in Printer
Configuration tab to setup the IP address, subnet mask and gateway for the on
board Ethernet.