Filter
Top Products
Chapter 2: Setting Up 45
2.8.2 Installing Chassis Foot Stands
The four feet should be attached as follows:
1. Each foot consists of two
pieces. Insert the round piece
of the foot into the larger foot
section. The small plastic tab
on the round piece should fit
into the curved slot on the
other piece.
2. Use a single screw
through the center of the
round section to fasten
the foot assembly to the
bottom of the chassis.
The plastic tab that
protrudes through the
curved slot should fit into
an indent in the chassis
case. When fitted, each foot should rotate about 90°.
3. Fit all four feet in the same way.
NOTE: When using as a standalone unit, all four feet should
be fitted and extended fully to prevent instability.
Curved slot
Tab fits in
curved slot