Filter
Top Products
10S1668-ATX-001 http://www.tyan.com
Reset Connector: J45
Pinout Assignment
1 Power Good
2 Ground
Turbo LED Connector: J42
Pinout Assignment
1 Cathode
2 Anode
Flash EEPROM: J32(Default 5V)
This jumper should be left at the factory default.
Voltage J32
5V 1-2 (default)
12V 2-3
InfraRed Interface: Con4 and Con5
Pinout Assignment
1 Signal In
2 Gnd
3 Signal Out
4 VCC
Super I/O Type: J26
Type J26
665IR 1-2
669IR 2-3
This setting depends on what type of SMC I/O chip
is installed on the board. This jumper is set at the
factory and should not be changed.