Ultra electronic 300 Printer User Manual


 
Quick Start Guide Ultra Electronics Card Systems
Page 32 MAGICARD Color Printer
X Start Position - This function allows the operator to adjust the position of the start of the
image. A 1% shift is approximately 0.1mm. For interfacing to earlier models, leave set at the
default value of 50, to prevent file errors.
X End Position - This function allows the operator to adjust the position of the start of the
image. A 1% shift is approximately 0.1mm. This adjustment only applies to Full Bleed models.
For interfacing to earlier models, leave set at the default value of 50, to prevent file errors.
YMC Power - allows the user to adjust the density of the Yellow, Magenta and Cyan print. For
interfacing to earlier models, leave set at the default value of 50, to prevent file errors.
Resin Power - allows the user to adjust the density of the Black Resin print.
Overcoat Power - allows the user to adjust the density of the Overcoat print. For interfacing
to earlier models, leave set at the default value of 50, to prevent file errors.
Colour Adjust
The default values for the Contrast, Brightness and color balance of the printed card may be
changed in this setup tab. Unless you know what you are doing, avoid changing the defaults.
About
Data on this page is for information only.
When the printer set up selections have been made, click on the OK button to close the setup
window and to accept any changes that have been made.
Note: Although you may be able to access the Printer Setup dialog window from within a
WINDOWS application, with some applications, the selected settings will prove to be volatile,
and will be lost when you quit WINDOWS.
Click on the RESTORE button to return to the original default values.
Click on the CANCEL button to close the setup window and to abandon any changes that
have been made.
For further information on installing and configuring printers to your PC, operating in a
WINDOWS environment, consult the Microsoft WINDOWS User's Guide.
Printing Monochrome Bitmaps
Driver versions 4.01 and later has an option to print graphics using the resin black panel of the
dye film. To print a bitmap on the resin black panel the format must be as a 1 Bit Bitmap
image file.