Filter
Top Products
Introduction
The Dyna-Switch/16 and Dyna-Switch/24 (Auto MDI/MDIX) are Fast
Ethernet switches that provide wire-speed, a Fast Ethernet switching
function which allows high-performance, low-cost connections to Full-
duplex, Half-duplex, 10Mbps and 100Mbps Ethernet networks. The
Switches are targeted at workgroup, department, or backbone computing
environments in SME (small, medium enterprise) businesses.
These Switches provides auto-sensing 10/100Mbps Ethernet RJ-45 ports
which automatically detect the speed of the device that you plug into them.
This switching function allows 10Mbps, 100Mbps, Full-duplex and Half-
duplex devices to communicate on the same network without having to
replace any infrastructure. This flexible feature allows your network a
timely, economical migration to 100Mbps Fast Ethernet.
Key Features
■
Automatic MDI/MDIX crossover for all ports
■
N-Way Auto-negotiation for 10/100Mbps transmissions
■
Store-and-Forward switching architecture
■
Auto-detection of full/half-duplex mode in all ports
■
Performs non-blocking full wire speed
■
8K-entry MAC address table
■
LED indicators for Power, Link/activity, and Full Duplex/Collision
■
19” Rack-mountable with included brackets
■
Conforms to IEEE 802.3, 802.3u, and 802.3x standard
Troubleshooting
The Switch can be easily monitored through panel indicators to assist in
identifying problems. This section describes common problems you may
encounter and possible solutions.
■ Power
If the power indicator does not light when the power cord is plugged
in, you may have a problem with the power outlet or cord. However, if
the power LED goes off after running for a while, check for loose power
connections, power losses or surges at the power outlet. Turn off
power, wait 30 seconds and turn power on again. If problem is still
not resolved, call for dealer’s assistance.
■ Cabling
Verify that the cabling type is correct. Make sure all cable connectors
are securely seated in the required ports. Use only standard
Unshielded Twisted-Pair (UTP), Category 3, 4, 5, or 5e cables. Use
only Category 5 or 5e when connecting with Fast Ethernet. Make
certain the maximum distance between the Switch and what it’s
connected to is 100 meters or less.
NOTE: Do not plug a standard telephone cord into an RJ-45 port.
This may damage the switch.
Product Specifications
General Specifications
Standard IEEE 802.3 10Base-T Ethernet
Compliance: IEEE 802.3u 100Base-TX Fast Ethernet
IEEE 802.3x Flow Control and Back-pressure
IEEE ANSI/IEEE 802.3 N-way Auto-negotiation
Protocol CSMA/CD
Ports: 10/100Mbps Auto-sensing RJ-45 ports with
Auto MDI/MDIX crossover
Data Transfer Rate: Ethernet: 10Mbps (half-duplex)
20Mbps (full-duplex)
Fast Ethernet: 100Mbps (half-duplex)
200Mbps (full-duplex)
72
For full coverage of your warranty, be sure
to register your product using the enclosed
registration card.