Filter
Top Products
Aluminum Mobile Rack 3-7
10. Replace the computer’s cover and reconnect the power and other external
cabling.
7. Position the docking case so its mounting holes align with the drive bay’s
mounting holes. Secure with the supplied mounting screws (two/four on
each side.)
8.
Attach the red SATA cable from the back of the unit to an available SATA port
on the system board or anySATA controller card. Connect the red and white
HDD Access/Activity signal cable to the HDD signal pins on your system board.
9. Connect an available 4-pin power cable from the system’s power supply to
the 4-pin connector on the back of the docking case. e power connector is
‘D’ shaped to ensure proper orientation when making the connection.
Docking
Module Data Cable and Power Connectors
Mounting a Drive in the Drive Case
Proceed with the following steps to install a 3.5-inch drive device in the Mobile Rack
drive case.
1.Remove the Mobile Rack drive case cover by removing the two mounting screws,
then sliding the cover towards the back of the unit.
Remove the Drive Case Cover
Slide Cover Off
Mounting
Screws
(x2)
HDD Access
Serial ATA (SATA) cable