Vantec UGT-UC302CB Computer Drive User Manual


  Open as PDF
of 7
 
UGT-UC302CB
Hardware Installation
You have successfully installed the 2-Port SuperSpeed
USB 3.0 ExpressCard/34.
7.
Driver Installation
Please follow the following steps for driver installation.
When you are booting up the laptop with the new
hardware installed, Windows will automatically detect and
display the 'Found New Hardware Wizard'.
Cancel the automatic driver installation and run the
Setup.exe located on the Driver CD. Setup.exe can also
be downloaded from our website www.vantecusa.com.
Run installer setup.exe on Driver CD X:\UGT-UC302CB\.
(where X is the drive path for your CD-ROM drive)
When installation of the driver is complete, please reboot
the system to complete the driver installation.
1.
2.
3.
4.
5.
Page 6
Note: When drivers have been successfully installed,
you may check if installation was successful within
Device Manager and will be shown as “NEC Electronics
USB 3.0 Host Controller”.
 previous