ViewSonic SCZ55BKUS0 Personal Computer User Manual


 
Setting Up Your SC-Z55
Assembling the AC Adapter
11
Step 5: Mount Your SC-Z55
To mount your SC-Z55 on the back of a monitor, please do the following:
1. Refer to Step 2 and Step 4 to prepare required screws for mounting your SC-Z55.
• You will need two (2) screws of type
2
to secure the bracket to your SC-Z55.
• You will need two (2) screws of type
1
or
2
to secure the bracket to the monitor.
2. Place your SC-Z55 on a at surface with the VESA mount hole side upward.
3. Refer to Step 2 to choose two of the four VESA mount holes on the bracket to align with two mount holes
on your SC-Z55 such that the bracket projects out and is closer to the rear panel than the front one as shown
below, and then secure the bracket to your SC-Z55 with two (2) screws of type
2
.
4. Align the mount holes on the bracket with the mount holes on the back of the monitor, and then secure the
bracket to the monitor with two (2) screws of type
2
or
1
. Ensure that your SC-Z55 is located in the center
of the monitor and the rear panel of your SC-Z55 is facing rightward as shown below.
2.2 Assembling the AC Adapter
To assemble the AC adapter for your SC-Z55, please do the following:
1. Unpack your zero client package and take out the AC adapter
and its detached plug.
2. Slide the plug into the AC adapter until it clicks into place.
NOTE
• The supplied plug may vary, depending on dierent areas.
Have SC-Z55’s rear panel
facing rightward.