Filter
Top Products
6
Getting Started
ViewSonic EF70
E
N
G
L
I
S
H
Power cord Video cable
Quick Installation
1 Connect video cable
Make sure both the monitor and
computer are powered OFF. Connect
the video cable to the computer.
Macintosh
®
users:
Connect a
Macintosh adapter to the video
cable, then to the computer. To
order a ViewSonic
®
Macintosh
adapter, send an email to vsparts
@viewsonic.com or contact
ViewSonic (see the back cover of
this guide). You will need to provide
your monitor's serial number.
2 Connect power cord
Connect the power cord from a properly
grounded AC outlet to the monitor.
3 Power-ON monitor and computer
Power-ON the monitor, then power-
ON the computer. This sequence
(monitor before computer) is very
important.
NOTE: At this point Windows
®
98
users may receive a message asking
them to install the EF70’s INF file.
4 Install INF and ICM files
• For CD-ROM: Insert the CD-ROM
into your system, wait for it to auto-
start, select “Monitor Drivers,” and
follow the on-screen instructions.
•
For diskette: Insert the diskette into
your system, run install.exe, and
follow the on-screen instructions.
5 Windows users: Setting the
Timing Mode (resolution and refresh
rate)
Example: 1024x768@ 75Hz.
For instructions on changing the resolu-
tion and refresh rate, see the user
guide for your computer's graphics
card.
6
Use the OnView
®
controls to
adjust the screen image.
See the
Operations
section in this
guide.
Wall socket
Installation is complete!
Enjoy your new EF70 Monitor!
To be best prepared for any future
customer service needs:
•
Write the serial number (see back
of the monitor) in
"For your Records"
on page 1 of this guide.
•
Register the warranty of your monitor
on the Internet at:
http://www.viewsonic.com