Filter
Top Products
ViewSonic PJ500
16
No Signal Menu
The same adjustments and settings are available with the Image
and Options menus when the MENU button is pressed during
display of the “No INPUT IS DETECTED ON ***” or “SYNC IS
OUT OF RANGE ON ***” message while no signal is received.
Table 8: No Signal Menu
Item Description
VOLUME
Volume Adjustment: Use the buttons.
When this function is used, audio input is automatically switched to video. The audio input
can be switched by moving the DISK PAD left and right during the display of the volume
adjustment bar. The volume adjustment bar is displayed by pressing VOLUME or
VOLUME button.
BLANK
Select Blank Screen Color: Select the color with the buttons.
When the blank mode is set with BLANK ON, by absence of a signal or by input of a non-
stndard signal, the image is cleared and the complete screen is displayed in the selected
color.
MIRROR
Operation Start/Stop: Use the buttons.
Select Mirror Status: Select the mirror status with the and buttons.
START UP
Operation Start/Stop: Press the buttons.
Setup Initial Screen Display: Select TURN ON with the button.
Clear Initial Screen Display: Select TURN OFF with the button.
NOTE: If TURN OFF is selected the blank screen is displayed in blue when there is no
signal.
MENU COLOR
Select Menu Background Color: Select the color with the buttons.
LANGUAGE
Operation Start/Stop: Press the buttons.
Select Menu Display Language: Select the language with the and buttons.
AUTO OFF
Operation Start/Stop: Press the buttons.
Set AUTO OFF: Set 1 ~ 99 minutes with the and buttons. The system automatically
enters the standby mode when a signal is not received for the set time.
Clear AUTO OFF: Select the STOP (0 min.) with the button. When the STOP is selected
the system does not enter the standby mode even if no signal is received.
SYNC ON G
Operation Start/Stop: Press the buttons.
SYNC ON G Valid: Select TURN ON with the button.
SYNC ON G Inalid: Select TURN OFF with the button.
NOTE: May not be displayed correctly with some input signals when SYNC ON G is valid.
In such cases, remove the signal connector so that no signal is received, set SYNC ON G
to invalid, and reconnect the signal.
WHISPER
Operation Start/Stop: Press the buttons.
Set/Clear Whisper Mode: Press the and buttons. When the WHISPER mode is
selected, the WHISPER mode is active. In this mode, acoustic noise level from the unit is
reduced, brightness level on screen is lowered and the lamp life is lengthened.
VOLUME
BLANK
MIRROR
START UP
MENU COLOR
LANGUAGE
AUTO OFF
SYNC ON G
WHISPER