Filter
Top Products
ViewSonic Pro8400 37
4. Press
to select the item you want to modify and press
ENTER
on the projector
or
Enter
on the remote control.
5. Press / to move the cursor and the enter the value.
6. To save the settings, press
ENTER
on the projector or
Enter
on the remote
control. If you do not want to save the settings, press
MENU/EXIT
on the projector
7. or
Menu
on the remote control.
8. Press
to highlight
Apply
and press
ENTER
on the projector or
Enter
on the
remote control.
Important
If the RJ45 cables are not properly connected, the IP Address, Subnet Mask,
Default Gateway, and DNS settings will display 0.0.0.0. Make sure the
cables are properly connected and perform the procedures above again.
If you wish to connect to the projector in its standby mode, be sure you have
selected RJ45 and obtained the IP Address, Subnet Mask, Default Gateway,
and DNS information when the projector is on.