Filter
Top Products
WireS
p
eed Dual Connect Modem
User Guide
Table 5. Ethernet Pinouts
Pinout Description
1 Rx+
2 Rx-
3 Tx+
4,5,7,8 Not Used
6 Tx-
5.6 Modem Installations
This section explains the procedures for installing Westell’s WireSpeed Dual Connect modem via USB connections
or via 10/100 Base-T/Ethernet connections.
Note: This product supports simultaneous use of Ethernet and USB ports. They may be connected
simultaneously if you are using two distinct IP addresses. Please wait until you have received
notification from your Service Provider that your DSL line has been activated before installing
your modem.
Note: If you are using a Westell ADSL modem in conjunction with a router, refer to the router manufacturer’s instructions for proper installation
and configuration.
5.6.1 Modem Installation via USB
Refer to Figure 2.
1. Place the modem on a flat surface that is near the PC.
2. Connect the power supply cord to the power connector marked
~
on the rear panel of the modem. Plug the
other end of the power supply cord into an AC wall socket.
12V
3. Connect the DSL phone cable from the connector marked on the rear panel of the modem marked to the
DSL-equipped telephone line jack on the wall. IMPORTANT: Do not
use a DSL filter on this connection. You
must use the phone cord that was provided with the modem kit.
4. Connect the USB cable from the USB connector marked
on the rear panel of the modem to the USB port
on the PC.
!
Note: When changing the modem between multiple computers with different operating systems or when upgrading the computer
attached to the modem, the power must be cycled on the modem.
030-300196 Rev. A 6