Filter
Top Products
MY BOOK MIRROR EDITION
USER MANUAL
REPLACING A DRIVE – 24
6. Replace the cover plate by sliding it under and between the pulltabs and securing
it with the thumbscrew.
Note: Do not overtighten the thumbscrew.
7. Close the cover and firmly push down until it locks into place.
8. Reconnect only the power cable to the device. Do not connect computer interface
cables.
9. The drive starts the rebuild process automatically and the LEDs cycle from bottom
to top. The RAID rebuild may take up to 12 hours depending on drive capacity
and activity, but typically will complete in 5-7 hours. Allow the RAID rebuild to
complete.
10.Once complete, the LEDs will glow steadily to indicate power-on state.
11.Connect the interface cable. The WD Drive Manager Status displays (see “WD
Drive Manager Status” on page 12).
12.Return the faulty drive following the instructions provided in the WD knowledge
base article# 1709.
Important: Do not attempt to use the device during the rebuild process.
Important: Do not disassemble the internal drive and attached assembly
components. Return the entire internal drive assembly intact to WD.