Whistler 800 WATT POWER INVERTER Power Supply User Manual


 
OPERATION SUMMARY
19
OPERATION SUMMARY
18
This inverter is designed to be connected to the power
source with the supplied cables or with #4 wire up to
12’ - #2 wire for longer length. When utilizing the sup-
plied cables do not attempt to modify or lengthen
them.
Always make certain that the power cable terminal con-
nections run Negative (-) to Negative (-) and Positive (+)
to Positive (+). Check these connections frequently to
ensure that they are secure.
Make certain the rated power consumption of the appli-
ance or equipment you wish to operate is compatible with
the capacity of your inverter.
If the rated power consumption of the equipment is in the
range of the maximum specified wattage of your convert-
er, test the inverter to ensure that it will operate properly.
This inverter is not designed to operate heat generating
appliances such as coffee makers, irons, hair dryers,
toasters and heaters.
Before attempting to use a battery charger see page 11.
Before attempting to use medical equipment see page 4.
Use only fuses which conform with the design specifica-
tions outlined in this manual.
When operating the inverter with the engine off, start the
engine every hour and let it run for at least 10 minutes to
recharge the battery.
In the event of automatic shut down, turn the inverter OFF
(O) immediately. Do not restart the inverter until the
source of the problem has been identified and corrected.
To avoid battery drain always disconnect the inverter
when not in use.
Do not expose the inverter to moisture.
Avoid placing the inverter near sources of heat or in
direct sunlight.
When in use, make certain that the inverter is properly
ventilated.
Do not use the inverter near flammable materials,
fumes, or gases.
Always operate the inverter in accordance with the
instructions in this manual. Failure to do so may result
in property damage, personal injury, or loss of life.