Xantech 480B-00 Network Card User Manual


  Open as PDF
of 3
 
IR Receivers
3
12-20-00
Rev. E
PHANTOM POWER CONNECTIONS
Some existing installations may have only 2 wires (such as coax) going to a remote room. The 480, when
used with a 792-10 Power Module, may be connected for 2-wire phantom power operation as follows:
Additional 480's may be wired in parallel at the 3-terminal block, up to a maximum of three. More than this
may cause unreliable results.
CAUTION: With any of these systems, be sure the 781 power supply is plugged into an un-switched AC
outlet. This maintains the 480 system in "standby" operation so that power-on commands can be sent to
the controlled equipment.
480-00
Series
IR Receivers
792-10
POWER MODULE
+12V
OUT
IN
GND
+12V
OUT
XANTECH CORPORATION
1 (ON)
0 (OFF)
1 2 3 4 5 6 7 8 910
ON
12345678910
792-10
Power Module
(In Phantom
High Current mode)
Red (or white)
Stripe
3-Terminal Block (supplied)
2-Conductor
Inter-room Cable
(usually coax)
OUT
+12V
GND
7' Ribbon Cable
To
282M
or
283M
Emitters
on controlled
equipment
Use wire jumper
between screws as
shown
REMOTE ROOM
HIGH IR
GROUND
EMITTERS
HIGH IR
IN / OUT
781RG
Power Supply
790-00
Connecting Block
MAIN ROOM
®
790
CONNECTING BLOCK
HIGH IR
IN / OUT
480 Series
 previous