Xantech HDMI1X4 Network Card User Manual


  Open as PDF
of 4
 
- 3 -
INSTRUCTIONS
1) Connect the supplied cable from the HDTV HDMI sources into the 1x4 HDMI Splitter input. HDMI
to HDMI cable for HDMI source or HDMI to DVI cable for DVI source.
2) Connect the cables from your displays (monitor or projector) into the HDMI outs of the 1x4 HDMI
Splitter.
3) Plug the 5VDC power supply into the 1x4 HDMI Splitter.
DIP SWITCH GUIDELINES
Inside the HDMI1X4 is a bank of Dip Switches. Below is a table describing their functions. By default,
all switches are set to the Off position.
Dip Switch # Name Description
1 Switching Delay Adds a 3 second delay to switching
2 On Board EDID Feeds a generic HDMI EDID (720p/1080i) to all inputs
3 IR Code Dip Switch Corresponds to Dip Switch 1 on RMT16-IR
4 IR Code Dip Switch Corresponds to Dip Switch 2 on RMT16-IR
5 Unused -
6 Unused -
7 Unused -
8 Edge Select + Edge Pixels
How to open the 1x4 HDMI Splitter:
To access the dip switches, just remove the four screws on the bottom. Slide the top portion off of the
bottom and you should see the dip switches on the board.
 previous