Filter
Top Products
Installation Guide
8
©2002 Xantrex Technology Inc. All Rights Reserved
P/N 973-0019-01-02 Rev A 06/2002
Figure 4
Installation for Ring-lugged Battery Cables
Installation (continued)
Cable Installation into Fuse Block (continued)
hex nut
hex nut
split-
washers
split-
washers
Ring-lug on
Battery Cables
Ring-lug on
Battery Cables
For Fuse Blocks designed for Ring-lugged Battery Cables (TFBxxx)
A. If necessary, install the ring-lugs (not supplied) onto
the battery cables. Ensure the terminal connector’s
have a 3/8" diameter opening for placement over the
stud connector on the fuse block.
1. Remove the 3/8" hex nut and split washers from the
fuse block.
2. Place the cable ring lugs over the 3/8-18 bolt on the
fuse block assembly and reinstall the split washer
and hex nut.
See Figure 4.
3. Tighten the hex nuts to 10-15 ft/lbs.
4. Repeat Steps 2, 3, and 4 for connection to the other
end of the fuse block.
NOTE: Do not place
anything
between the
ring-lug on the
battery cable
and the terminal
surface.
Terminal surface
Terminal surface
3/8-18
bolt
3/8-18
bolt