Filter
Top Products
Specifying input parameters
Using LCDS Print Description Language 2-57
Default EBCDIC
VOLUME CODE
parameter: points
to note
• When you run a CODE=NONE job with DUPLEX=YES and
SHIFT=YES, you must specify MARGIN in inches.
• Input data is translated according to the CODE selected on
the VOLUME command. Any character that is translated into
an ASCII X’20’ is truncated after the last significant (non-
ASCII X’20’) character in the print record.
• On the DP EPS, trailing spaces are deleted for the current
code set only. In addition, translated characters that are
beyond the highest character code in the current font are
converted to blanks and potentially removed.
VOLUME DBCODE
Specifies which double-byte character code translation table the
system will use to interpret the input data.
Syntax VOLUME DBCODE = {keyword | id }
Options
Default No default
VOLUME DBCS
Specifies the double-byte character printing mode. Allows
printing of data streams of intermixed single-byte and double-
byte characters.
Table 2-59. VOLUME DBCODE parameter options and definitions
Option Definition
keyword Specifies a specific, standard, system defined double-byte code translation
table. The available options are:
• IBM: IBM Nihongo character set (Kanji double-byte character sets)
• IBMCHN: IBM 5550 code translation table
• JEF: Fujitsu JEF Kanji double-byte character set
• KEIS: Hitachi KEIS Kanji double-byte character set
• USER: Refers to the single unlabeled DBCODE command defined within
the JDL or JDE.
id Specifies an identifier label that was used in a previously defined DBCODE
command to refer to a specific, user-defined code translation table. The id label
is required when multiple DBCODE commands are contained within the JDL.