Filter
Top Products
4-3
Step 9 : Be sure that the media is loaded centrally. This to be sure that the media is wound up straight.
This can be easily checked by the yellow labels on the winding rails. Be sure to mount the left
and right roll unit on the same distance from the 0I0 label.
Step 10 : Install an empty core between the front roll units.
a. Make sure the core is longer than the media width.
b. Load it centrally as described in previous step
Step 11 : Use the foot-switch to release some media at the rear.
Step 12 : Load media through the rear tensioning bar, over the print platform, under the pressure rollers as
pictured below.
1
Roll unit
2
Media roll
3
Rear tensioning bar
4
Print platform and
pressure rollers
Outside printable Inside Printable