Filter
Top Products
XEROX WIDE FORMAT COPY SYSTEM Special features keys • 69
The OUTPUT BIN option enables you to specify which finisher output bin
to use for the finished output. The choices are DON'T CARE, BIN X
(where X equals 1 to the actual number of finisher bins), FANFOLD, and
BYPASS. BYPASS is the factory default setting.
OUTPUT BIN
OUTPUT BIN: BYPASS
Sets Build key
The Sets Build mode allows you to scan a series of images and build an
electronically collated set. Once the set is built, one or more collated
copies can be printed.
NOTE: The Sets Build mode is not available unless the WIDE FORMAT
COPY SYSTEM is in the COPY mode.
NOTE: Any of the finishing options can be changed during a Sets Build
job. The option(s) must be changed before the document to be copied is
inserted.
In Sets Build mode, documents of C (A2) size and larger are normally
delivered to the rear of the Scanner after the scan. If the DOCUMENT
RETURN parameter is set to REAR, then all documents are delivered to
the rear after scanning. The WIDE FORMAT SCAN SYSTEM is
equipped with a document catching device, called the Stacker, to receive
these documents. Refer to "Scanner Control" in the "Main Menu" section
of this manual for further information about the DOCUMENT RETURN
parameter.
To build a collated set:
1. Press the Sets Build key. The Sets Build indicator lamp
illuminates and the SETS BUILD screen are displayed.
SETS BUILD
COLLATION: FORWARD
OUTPUT BIN
Preparing to build the
set
Building and printing
the set