Filter
Top Products
30
Installation for Windows 3.1x and Windows NT 4.0. 95 or
98
The Printer Driver Installation software cannot be installed using the Control
Panel/Printers for Win 3.1x or the Add Printer Wizard for Win
95/98/NT4.0. Please use one of the following methods depending on your
operating system.
1. Ensure that the computer and the
WorkCentre are turned off.
2. Plug the IEEE-1284 cable into the
parallel port on the WorkCentre.
3. Plug the other end of the IEEE-1284
cable into the computer.
4. Turn on the PC.
NOTE: Be sure to close all applications before installing the printer driver.
5. Start Windows on your computer.
6. Insert the WorkCentre XE CD-ROM into the CD-ROM Drive.
7. For Installation of 3.1x:
Choose File from the menu bar in Program
Manager, and then choose the Run… command.
For Installation for Windows NT 4.0, 95 or 98
: Click on the Start
button and then choose the Run menu option.
8. Type D:\SETUP (or the appropriate drive letter depending on your CD-
ROM Drive) in the command line box. Click on the OK button to
proceed.
9. Follow the on-screen instructions.
10. For Installation of Windows 3.1x:
When the install is complete,
ensure that the power cord is plugged into the WorkCentre and then
into a grounded outlet. Restart Windows and turn on the WorkCentre.
For Installation for NT 4.0, 95 or 98
: When the installation is
complete, ensure that the power cord is plugged into the WorkCentre
and then into a grounded outlet. You will be asked whether or not to
print a test page. If you wish to do so, load paper, turn on the
WorkCentre and then click the Yes button.