Filter
Top Products
8. Fan Power Cable Connection
7. VGA Card Installation
Insert the assembled VGA card into the motherboards PCIe (or AGP) slot. Use the Fixing Bolt to secure the
VGA card onto the computer case. If the VGA card has a power connector on it, then remember to plug in the
power cable.
PCIe Slot
Fixing Bolt
5
Installing FAN MATE 2 on the Inside of the System
Installing FAN MATE 2 on the Outside of the System
Connect the appropriate 3-pin connector on the
cable to the motherboard fan header and the
Z-Machine GV1000 fan connector.
Pull the 6-pin connector out of the system through
the back and connect it to FAN MATE 2, which
should be installed on the case using the included
Double-Sided tape ().
When the RPM Control Knob on FAN MATE 2 is turned fully counter-clockwise, the fan operates in Quite
Mode. Turned fully clockwise, it operates in Performance Mode. You can select the desired fan RPM by
turning the knob.
Performance can be increased by adjusting the RPM control knob of the FAN MATE 2.
Note) FAN MATE 2 has been specifically designed for the fan of this product.
Zalman Tech Co., Ltd. is not responsible for any damage to systems or VGA Chipsets caused by
using it with other types of fans.
RPM Control Knob
Fan Connector
(Z-Machine GV1000)
Motherboard
Double - Sided Tape
FAN MATE 2
6-Pin
Connector