Filter
Top Products
Routine Maintenance
Cleaning Schedule and Procedures
124
P1009874-002 Xi4™/RXi4™ User Guide 1/7/10
Clean the Snap Plate
Clean the snap plate when label adhesive or a label is stuck to the underside. Figure 20 shows
the location of the snap plate. The snap plate is made of plastic in RFID printers and of metal
in non-RFID printers.
Figure 20 • Snap Plate Location
Non-RFID Printers
To clean a metal snap plate in a non-RFID printer, complete these steps:
1.
2.
Important • Be careful not to bend or twist the metal snap plate as you remove it from or
insert it into the printer.
Caution • Turn off (O) the printer and disconnect it from the power source before
performing the following procedure.
Turn off (O) the printer, and disconnect the AC power cord and all data cables.
Caution • While performing any tasks near an open printhead, remove all rings,
watches, hanging necklaces, identification badges, or other metallic objects that could
touch the printhead.
Open the printhead and remove the media and ribbon (if used).