Filter
Top Products
Advanced Setup
62 6212-I3 4-Port Router User’s Guide 6212-A2-ZB83-20
Modulation Methods
The following modulation methods are supported by the 6212 ADSL router:
z G.d mt En ab le d
z G.lite Enabled
z T1.413 Enabled
z ADSL Enabled
z Annex L Enabled
z ADSL2+ Enabled.
Do not change this setting unless so directed by your ISP.
Capability
The following are included under Capability:
z Bitswap Enable
z SRA (Seamless Rate Adaptation) Enable
Do not change these settings unless so directed by your ISP.
DSL Advanced Settings
Do not change the DSL Advanced Settings unless so directed by your ISP. To
view the DSL Advanced Settings screen, click on the Advanced Settings
button on the DSL Settings screen (see Figure 69).
There are five test modes between the router and your ISP:
z Normal test: Puts the router in a test mode in which it only sends a
Normal signal.
z Reverb test: Puts the router in a test mode in which it only sends a Reverb
signal.
z Medley test: Puts the router in a test mode in which it only sends a
Medley signal.
z No Retrain: In this mode the router will try to establish a connection as in
normal mode, but once the connection is up it will not retrain if the signal
is lost.
z L3: Puts the router into the L3 power state.
Select a test mode and click on Apply. Then click on Tone Selection.