Filter
Top Products
ZNYX Networks NetBlaster ZX222 PMC Fast Ethernet Adapter · User’s Guide Page 4
Hardware Installation
Below are the steps necessary to install a NetBlaster adapter into a standard, PMC compliant
system. The following are detailed instructions for the hardware installation procedure.
Installing the Hardware
This installation procedure is for installing NetBlaster PMC adapter systems with an embedded
PMC slot. Some steps in this procedure may vary depending on the specific system used. Refer
to the system’s documentation if necessary.
The figure on the following page shows the installation of an adapter in a typical system.
Zx222 PMC Adapter
Observe proper Electro-Static Discharge prevention
procedures at all times. Failure to do so may result
in damage to the PCI Adapter or to the system.
!
!
Do not use excessive
force.
0 I
Ω
CPCI PMC Carrier Card
1. Turn off your system.
2. Discharge any static electricity from your body by touching the metal chassis, or by using
an anti-static wrist strap. If you do not have a ground strap, maintain physical contact with
the case to maintain the same electrical potential with the system.
3. Remove the motherboard or carrier card containing at least one available single-wide
PMC slot. Select a slot to install the ZNYX Networks NetBlaster adapter. Remove the cover
from the PMC slot.