Filter
Top Products
Page 6 ZNYX
ZNYXZNYX
ZNYX NetBlaster ZX410 Series User’s Guide
Testing ZX412 and ZX414 Adapters
1. Run the diagnostic program that came with your adapter to see if your adapter has been
properly configured. Run DIAG41x.EXE off your diskette by entering:
>DIAG41x LIST
2. You will see a list below. (This example is for the ZX414.)
DIAG414 Version 1.38 for ZNYX NetBlaster ZX414 4/100 Mbps adapter
(c) Copyright 1994-1998 ZNYX Corporation - All Rights Reserved.
PCI BIOS Information: Version=2.10, Config Mechanism=1, Last Bus=2
Bus Dev Fn Vendor Device Rev Type Lat IL IRQ Note
========== ================= ============ ========== =====
0 0 0 8086 1250 03 Host Bridge 20 - -
0 7 0 8086 7000 01 PCI-ISA 00 - -
0 7 1 8086 7010 00 IDE 20 - -
1 4 0 1011 0019 30 Ethernet 40 A 9 ZX414
1 5 0 1011 0019 30 Ethernet 40 A 3 ZX414
1 6 0 1011 0019 30 Ethernet 40 A 10 ZX414
1 7 0 1011 0019 30 Ethernet 40 A 5 ZX414
3. If you see a list of two or four 02-Network/00-Ethernet channels, each with an
IRQ
(interrupt line),
bus
value, and a unique
device
number, your card has been automatically
configured. Make a note of the bus and device numbers and go on to the software installation
section.
4. Test all channels of your adapter by running DIAG41X for each bus number and device
number. For example, if you have a ZX414 the bus number is 1 and the device numbers are
from 4-7, run:
>DIAG414 1 4
>DIAG414 1 5
>DIAG414 1 6
>DIAG414 1 7
5. Substitute the appropriate version of DIAG41X for the adapter used. If the DIAG41X
program says:
Diagnostics successfully completed.
each time, proceed with the software installation.
6. If the DIAG41X program does not indicate a successful completion, refer to the chapter on
troubleshooting in this manual.