ZyXEL Communications 100-NH Network Router User Manual


 
Chapter 11 Troubleshooting
NWA1000 Series User’s Guide
119
Advanced Suggestions
Try to access the NWA using another service, such as Telnet. If you can access the NWA, check
the remote management settings to find out why the NWA does not respond to HTTP.
If your computer is connected wirelessly, use a computer that is connected to a LAN/Ethernet
port.
I can see the Login screen, but I cannot log in to the NWA.
1 Make sure you have entered the user name and password correctly. The default user name is
admin and default password is 1234. This fields are case-sensitive, so make sure [Caps Lock] is
not on.
2 Disconnect and re-connect the power adaptor or cord to the NWA.
3 If this does not work, you have to reset the device to its factory defaults. See Section 2.3 on page
20.
I cannot use FTP to upload new firmware.
See the troubleshooting suggestions for I cannot see or access the Login screen in the web
configurator. Ignore the suggestions about your browser.
11.3 Internet Access
I cannot access the Internet through the NWA.
1 Check the hardware connections, and make sure the LEDs are behaving as expected. See the Quick
Start Guide and Section 11.1 on page 117.
2 Make sure your NWA is connected to a networking device that provides Internet access.
3 Make sure your computer is set to obtain a dynamic IP address or has an IP address which is in the
same subnet as the broadband modem or router.
4 If you are trying to access the Internet wirelessly, make sure the wireless settings on the wireless
client are the same as the settings on the AP.
5 Disconnect all the cables from your device, and follow the directions in the Quick Start Guide again.
6 If the problem continues, contact your ISP.