Filter
Top Products
Prestige 2802HW(L)-Ix Support Notes
All contents copyright (c) 2007 ZyXEL Communications Corporation.
24
pre-configured, read only, Many-to-One mapping set,
sufficient for most purposes and helpful to people
already familiar with SUA in previous ZyNOS
versions. Note that there is also a Server type whose
IGA is 0.0.0.0 in this set.
2. Address Mapping Sets and NAT Server Sets
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global addresses
to LAN clients. Each remote node must specify which NAT Address Mapping Set to use. The P2802HWL has
8 remote nodes and so allows you to configure 8 NAT Address Mapping Set. You can see nine NAT Address
Mapping sets in WEB GUI Network > NAT > Address Mapping. You can only configure from Set 1 to
Set 10 when you select Full Feature in WEB GUI NAT configuration. When you select SUA Only, the Port
Forwarding
will auto configure as to Many to one and Server as default in system.
The NAT Server Set is a list of LAN side servers mapped to external ports. To use this set (one set for the
Prestige), a server rule must be set up inside the NAT Address Mapping set. Please see NAT Server Sets for
further information on these menus.
Enter WEB GUI Network > NAT > Address Mapping to bring up Address Mapping Sets Menu.
Now let's look at WEB GUI Menu Network > NAT > Address Mapping.