Filter
Top Products
Chapter 7 Basic Setting
ES-3148 User’s Guide
81
Static IP
Address
Select this option if you don’t have a DHCP server or if you wish to assign static IP
address information to the Switch. You need to fill in the following fields when you select
this option.
IP Address Enter the IP address of your Switch in dotted decimal notation for example 192.168.1.1.
IP Subnet
Mask
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.1.254.
VID Enter the VLAN identification number associated with the Switch IP address. VID is the
VLAN ID of the CPU and is used for management only. The default is "1". All ports, by
default, are fixed members of this "management VLAN" in order to manage the device
from any port. If a port is not a member of this VLAN, then users on that port cannot
access the device. To access the Switch make sure the port that you are connected to
is a member of Management VLAN.
Out-of-band Management IP Address
IP Address Enter the IP address of your Switch in dotted decimal notation for example 192.168.0.1.
If you change this IP address, make sure the computer connected to this management
port is in the same subnet before accessing the Switch.
IP Subnet
Mask
Enter the IP subnet mask of your Switch in dotted decimal notation for example
255.255.255.0.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation, for
example 192.168.0.254.
Apply Click Apply to save your changes to the Switch’s run-time memory. The Switch loses
these changes if it is turned off or loses power, so use the Save link on the top
navigation panel to save your changes to the non-volatile memory when you are done
configuring.
Cancel Click Cancel to reset the fields.
In-band IP
Addresses
You can create up to 64 IP addresses which are used to access and manage the Switch
from the ports belonging to the pre-defined VLAN(s). You must configure a VLAN first.
IP Address Enter the IP address for managing the Switch by the members of the VLAN specified in
the VID field below.
IP Subnet
Mask
Enter the IP subnet mask in dotted decimal notation.
VID Type the VLAN group identification number.
Default
Gateway
Enter the IP address of the default outgoing gateway in dotted decimal notation.
Manageable Select this option to allow the Switch to be managed using this specified IP address.
Add Click Add to save the new rule to the Switch’s run-time memory. It then displays in the
summary table at the bottom of the screen.
Cancel Click Cancel to reset the fields.
Index This field displays the index number of an entry. Click an index number to edit the rule.
IP Address This field displays the IP address.
IP Subnet
Mask
This field displays the subnet mask.
VID This field displays the VLAN identification number of the network.
Default
Gateway
This field displays the IP address of the default outgoing gateway.
Table 12 Basic Setting > IP Setup (continued)
LABEL DESCRIPTION