Filter
Top Products
Chapter 2 Fiber-optic Connection
MC1000-SFP-FP User’s Guide
20
Figure 12 Insert Cable
2.6 Close the MC1000-SFP-FP
After you have disabled DIP switch 1 (LFS), installed the SFP transceiver, attached the wire
mounts, threaded fiber-optic cable though a bushing, wrapped excessive fiber-optic cable
around the wire mounts, inserted the fiber-optic cable into the SFP transceiver and enabled
DIP switch 1 (LFS) again, you should close the housing cover and secure it with the same
screws you removed as shown in Section 2.2 on page 15.
1 Close the cover as shown.
Figure 13 Close The Cover
2 Screw the cover back on the housing as shown.
Figure 14 Replace Housing Cover Screws