Filter
Top Products
PoE-10 Single-port Power over Ethernet Injector
9
Power Over Ethernet Injector RJ-45 Port Pin Assignments
PIN NO RJ-45 SIGNAL ASSIGNMENT
1 Output Transmit Data +
2 Output Transmit Data -
3 Receive Data +
4 Power +
5 Power +
6 Receive Data -
7 Power -
12345678
8 Power -
Troubleshooting
Make sure you have securely attached the proper cables to the proper ports.
Refer to the Rear Panel and Connections section for this information. If your
PoE-10 still does not work properly, refer to the table shown next.
PROBLEM CORRECTIVE ACTION
No LEDs are on when
I connect the PoE-10.
Check to see that the enclosed power adapter is properly
connected to the PoE-10 and an appropriate power source.
Make sure the power source is on and functioning properly.
If the problem persists, your power adaptor may have
malfunctioned. Contact your local distributor.
The LNK LED is not
on.
Check to see that the Ethernet cables are connected properly
and that you are using the correct type of cable. Refer to the
Rear Panel and Connections section for this information.
If the problem persists, contact your local distributor.
The LNK LED is
flashing.
Make sure that the connected Ethernet device is PoE-enabled
and is not malfunctioning.
If the problem persists, try connecting a different PoE-enabled
device to the PoE-10’s PWR&DATA port.
The PoE-10 can send Ethernet traffic to a device that is not
PoE-enabled, but not power.
Power is not being
supplied to my
PoE-enabled device.
Ensure that the Ethernet cable connecting the PoE-enabled
device to the PoE-10’s PWR&DATA port is securely attached.
Make sure the PoE-10 is connected to an appropriate power
source and that the power source is on and functioning
properly.