Filter
Top Products
ZyWALL 10~100 Series Internet Security Gateway
Log Descriptions 13-17
Log Commands
Go to the command interpreter interface (the Command Interpreter Appendix explains how to access and use
the commands).
Configuring What You Want the ZyWALL to Log
Use the sys logs load command to load the log setting buffer that allows you to configure which logs
the ZyWALL is to record.
Use sys logs category followed by a log category and a parameter to decide what to record
Chart 13-13 Log Categories and Available Settings
LOG CATEGORIES AVAILABLE PARAMETERS
access 0, 1, 2, 3
attack 0, 1, 2, 3
error 0, 1, 2, 3
ike 0, 1, 2, 3
ipsec 0, 1, 2, 3
javablocked 0, 1, 2, 3
mten 0, 1
upnp 0, 1
urlblocked 0, 1, 2, 3
urlforward 0, 1
Use 0 to not record logs for that category, 1 to record only logs for that category, 2 to record only
alerts for that category, and
3 to record both logs and alerts for that category.
Use the sys logs save command to store the settings in the ZyWALL (you must do this in order to
record logs).
Displaying Logs
Use the sys logs display command to show all of the logs in the ZyWALL’s log.
Use the sys logs category display command to show the log settings for all of the log categories.