A SERVICE OF

logo

92 Troubleshooting
Allocation Error for: device Run “Load Default Settings” in BIOS Setup Utility.
RTC battery
System board
Failing Bits: nnnn DIMM
BIOS ROM
System board
Fixed Disk n None
Invalid System
Configuration Data
BIOS ROM
System board
I/O device IRQ conflict Run “Load Default Settings” in BIOS Setup Utility.
RTC battery
System board
Operating system not found Enter Setup and see if fixed disk and drive A: are
properly identified.
Diskette drive
Hard disk drive
System board
No-Beep Symptoms
Symptom / Error Action in Sequence
No beep, power-on
indicator turns off and LCD
is blank.
Power source (battery pack and power adapter).
See “Power System Check” on page 88.
Ensure every connector is connected tightly and
correctly.
Reconnect the DIMM.
LED board.
System board.
No beep, power-on
indicator turns on and LCD
is blank.
Power source (battery pack and power adapter).
See “Power System Check” on page 88.
Reconnect the LCD connector
Hard disk drive
LCD inverter ID
LCD cable
LCD Inverter
LCD
System board
Error Messages List
Error Messages Action in Sequence