7.5.4. XFC 225 and XFC 1000
Use the following procedure to clean or replace the filter cartridge:
1. Unlatch the clamp that secures the cover assembly.
2. Lift off the cover.
3. Unscrew the retaining cover, and remove the filter cartridge.
4. Use compressed air to clean the filter cartridge. Blow from the inside to the outside of
the filter cartridge. Make sure that the compressed air pressure is less than 100 PSI (6.9
Bar) to keep from damaging the filter. Replace the filter cartridge if it shows signs of
wear.
5. Wipe down the gasket and filter retainer cover mating surfaces to ensure a good seal.
6. Re-install the filter cartridge. Make sure the filter cartridge is properly seated in the
housing.
7. Re-install the retaining cover. A snug fit is required for a proper fit. Do not over
tighten the retaining cover.
8. Place the cover on top of the filter assembly
9. Latch the clamp that secures the cover assembly.
Spare Parts
XFC 225 Filter Cartridge: A0547008
XFC 1000 Filter Cartridge: A0547007
31
