DS3 Cell Switch Module
Specifications are subject to change without notice. ADTRAN is a trademark of
ADTRAN, Inc. All other registered trademarks and trademarks mentioned in this
publication are the property of their respective owners.
Total Access 3000 DS3 Cell Switch Module
ADTRAN is a
TL 9000 registered company.
ADTRAN is an
ISO 9001:2000 registered company.
ADTRAN, Inc.
901 Explorer Boulevard
Huntsville, AL 35806
P.O. Box 140000
Huntsville, AL 35814-4000
256 963 8000 voice
256 963 8030 fax
877 457 5007 fax back
General Information
800 9ADTRAN
info@adtran.com
www.adtran.com
Pre-Sales
Technical Support
888 5ADTRAN
support@adtran.com
www.adtran.com/support
Where to Buy
800 827 0807
www.adtran.com/where2buy
Post-Sales
Technical Support
800 726 8663
support@adtran.com
www.adtran.com/support
Regional Offices
Dallas, TX
972 830 9070
Denver, CO
303 471 9150
Irvine, CA
949 260 3500
Kansas City, KS
800 471 8649
Newark, NJ
800 471 8656
Ontario, Canada
416 290 0585
Quebec, Canada
877 923 8726
San Antonio, TX
888 223 7671
International Inquiries
256 963 8000 voice
256 963 6300 fax
international@adtran.com
www.adtran.com/international
Product Specifications
Front Panel Features
LEDs
■
Power
■
Status
■
Test
■
ATM
■
Clock
■
Lockout
■
On Line
Mechanical
■
Single Total Access 3000 multiplexer slot
■
DSX-3 interface through 1181004L1 coax adapter on
backplane
Interface
Network Interface
■
DS3 unchannelized interface
■
ATM UNI 3.1/4.0 compliance
■
C-bit parity (can be disabled through management
interface)
■
Payload scrambler on by default (can be disabled
through management interface)
Subscriber Interface
■
ATM UNI 3.1/4.0 compliance
■
Direct mapped ATM cells
■
Payload scrambler per subscriber on by default (can
be disabled through management interface)
■
Single-bit Header Error Correction option (on per sys-
tem basis)
Electrical
Power requirements
■
–42 to –56 VDC input voltage range
■
Fully operational with either A or B power feed
Regulatory Standards
■
NEBS Level 3
■
GR-1089-CORE
■
UL 1950
Management
■
Supports AIS, RDI, OAM loopback
■
OAM&P interface
■
TL1 and SNMP management support through SCU
■
Supported by Total Access EMS management system
■
Synchronized PM and provisioning between active
and standby units
■
QoS reporting and management
■
In-band VPI/VCI for SNMP management traffic
Automatic Protection Switching (APS)
■
1:1 equipment protection available
■
Front panel manual APS control switch
Timing
■
External BITS, line, or local timing modes
■
Optional S3E holdover
ATM Switching
■
Supports ATM traffic classes
■
CBR
■
VBRrt
■
VBRnrt
■
UBR
■
Per VC queuing and scheduling
■
7900 VC capacity
Environmental
■
Operating: –40° to +65°C
■
Storage: –40° to +85°C
■
Relative Humidity: Up to 95 percent, noncondensing
Ordering Information
Equipment Part #
DS3 Cell Switch Module 1181041L2
■ Fully hot-swappable (ESD wrist strap required)
■ Full feature set available when a single multiplexer installed
Printed in the USA
61181041L2-8B March 2003
©2003 ADTRAN, Inc. All rights reserved.
