OmniSwitch Troubleshooting Guide September 2005 page -5
show tech-support layer3 rip
Creates a log file of the output of several Routing Information Protocol (RIP) Command Line Interface
(CLI) commands.
show tech-support layer3 rip
Syntax Definitions
N/A
Defaults
N/A
Platforms Supported
OmniSwitch 6624, 6648, 7700, 7800, 8800
Usage Guidelines
• This command creates a file called tech_support_rip.log in the /flash directory of the output produced
by the show ip rip, show ip rip routes, show ip rip redist-filter, show ip rip redist, show ip rip
interface, show ip rip peer, and show ip rip debug CLI commands.
• If an existing file called tech_support_rip.log already exists then it will be overwritten when this
command is executed.
• See the OmniSwitch CLI Reference Guide for more information on show commands.
• See Appendix B, “Debug Commands,” for more information on debug commands.
Examples
-> show tech-support layer3 rip
.......
Release History
Release 5.1; command was introduced.
Related Commands
show tech-support Creates a log file of the output of system-wide CLI commands.
show tech-support layer2 Creates a log file of the output of several Layer 2 CLI commands.
show tech-support layer3 Creates a log file of the output of several Layer 3 CLI commands.
