AR-7H Hot Holding Rotisserie Companion Operation & Care Manual • 7
I N S TA L L AT I O N
S TA C K I N G IN S T R U C T I O N S
T
he holding cabinet can be stacked with an
identical holding cabinet or a matching rotisserie
o
ven in either the top or bottom position.
Only screws, lock washers, and hex nut are
required to fasten units together when stacking a
rotisserie on top of a matching holding cabinet or a
holding cabinet on top of a holding cabinet.
Additional stacking hardware is required for all
other combinations (
SEE PREVIOUS PAGE).
All fastening holes have been prepunched. If the
rotisserie oven is positioned at the bottom of a
stacked configuration, make certain the oven is on a
non-combustible surface. The stacking combination
also requires the minimum clearance of 6-inches
(152mm) at the back and both sides.
ᕡ
Remove the two side access panels of both units.
ᕢ Carefully lift and place the upper unit into
position aligning on bottom unit.
ᕣ Secure units together by inserting a hex head
screw, a flat washer, and a lock washer in each
hole of the top unit and screwing them into the
inserts provided on the top of the lower unit.
Securely tighten all four screws.
ᕤ Replace the side panels on both units.
AR-7H OVER AR-7H HOLDING CABINET STACKING ASSEMBLY (5009711)
ITEM
NO
.
PART
NO
.
PART DESCRIPTION QTY
1 NU-2437 NUT, 1/4-20 HEX S/S 4
2 SC-27385 SCREW, 1/4-20 X 3/4" LG HEX HEAD 4
3 WS-22094 WASHER, 1/4", FLAT, 5/8 OD 18-8 SS 8
4 WS-2294 WASHER 1/4" SPLIT 4
