4040
4040
40
1. JBOD function on this motherboard is only supported with single SATA / SATAII
HDD.
2. If you want to enable Hot Plug function on eSATAII ports but you install OS on
IDE HDD, please skip step 2 and step 3.
STEP 4: Install Windows
®
2000 / Windows
®
XP / Windows
®
XP 64-bit OS on
your system.
After step 1, 2, 3, you can start to install Windows
®
2000 / Windows
®
XP / Windows
®
XP 64-bit OS on your system. At the beginning of Windows
®
setup, press F6 to install
a third-party RAID driver. When prompted, insert the SATA / SATAII driver diskette
containing the ATI
TM
RAID driver. After reading the floppy disk, the driver will be
presented. Select the driver to install according to the OS you install. (Select “ATI
AHCI Compatible RAID Controller-x86 platform” for Windows
®
2000 and Windows
®
XP, or “ATI AHCI Compatible RAID Controller-x64 platform” for Windows
®
XP 64-bit.)
Using SATA / SATAII HDDs and eSATAII devices with NCQ and Hot Plug
functions
STEP 1: Set Up BIOS.
A. Enter BIOS SETUP UTILITY Advanced screen IDE Configuration.
B. Set the “SATA Operation Mode” option to [RAID].
STEP 2: Make a SATA / SATAII driver diskette.
Make a SATA / SATAII driver diskette by following section 2.16.1 step 2 on page
37.
STEP 3: Enter BIOS RAID utility (FastBuild Utility) to create JBOD on SATA /
SATAII HDD.
Restart your system. Press <Ctrl+F> to enter BIOS RAID utility (FastBuild Utility) to
create JBOD on SATA / SATAII HDD. For the proper operating procedures of
creating JBOD, please refer to the BIOS RAID installation guide part of the
document in the following path in the Support CD:
.. \ RAID Installation Guide
Using SATA / SATAII HDDs and eSATAII devices without NCQ and Hot Plug
functions
STEP 1: Set up BIOS.
A. Enter BIOS SETUP UTILITY Advanced screen IDE Configuration.
B. Set the “SATA Operation Mode” option to [non-RAID].
STEP 2: Install Windows
®
2000 / Windows
®
XP / Windows
®
XP 64-bit OS on
your system.
