2929
2929
29
BIOS SETUP UTILITY
CPU Configuration
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
v02.54(C) Copyright 1985-2003, American Megatrends, Inc.
Advanced
Select Screen
Select Item
+- Change Option
F1 General Help
F9 Load Defaults
F10 Save and Exit
ESC Exit
CPU Frequency (MHz)
AGP Frequency (MHz)
Overclock Mode
[200]
[66]
[Auto]
Spread Spectrum
Cool'n'Quiet
[Auto]
[Auto]
Processor Maximum Multiplier
Processor Maximum Voltage
x9 1800 MHz
1.400 V
Boot Failure Guard
[Enabled]
Multiplier/Voltage Change
[Manual]
If AUTO, multiplier and
voltage will be left at the
rated frequency/voltage. If
Manual,
will be set based
on UserSelection in Setup.
multiplier and
voltage
BIOS SETUP UTILITY
Processor Multiplier
Processor Voltage
Memory Clock
Flexibility Option
CAS Latency
TRAS
[x8]
[1.500V]
[Auto]
[Auto]
[Auto]
[Disabled]
Processor Multiplier
This item will show when “Multiplier/Voltage Change” is set to [Manual];
otherwise, it will be hidden. The range of the value depends on the CPU
you adopt on this motherboard. However, for system stability, it is not
recommended to adjust the value of this item.
Processor Voltage
This item will show when “Multiplier/Voltage Change” is set to [Manual];
otherwise, it will be hidden. The range of the value depends on the CPU
you adopt on this motherboard. However, for safety and system stability,
it is not recommended to adjust the value of this item.
Memory Clock
This item can be set by the code using [Auto]. You can set one of the
standard values as listed: [133 MHz (DDR266)], [166 MHz (DDR333)],
[200 MHz (DDR400)].
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
CAS Latency
Use this item to adjust the means of memory accessing. Configuration
options: [Auto], [2.0], [3.0], and [2.5]. The default value is [Auto].
TRAS
Use this to adjust TRAS values. Configuration options: [Auto], [5CLK], [6CLK],
[7CLK], [8CLK], [9CLK], [10CLK], [11CLK], [12CLK], [13CLK], [14CLK], and
[15CLK]. The default value is [Auto].
TRP
Use this to adjust TRP values. Configuration options: [Auto], [2CLK], [3CLK],
[4CLK], [5CLK], and [6CLK]. The default value is [Auto].
TRCD
Use this to adjust TRCD values. Configuration options: [Auto], [2CLK], [3CLK],
[4CLK], [5CLK], and [6CLK]. The default value is [Auto].
