September 1995 Issue 1 7-1
7
Activate the System
This chapter contains procedures for activating the system and bringing the
switch up to a non-alarm (no red lights) state. This chapter details:
■ Powering up the switch
■ Installing translation flash-memory card
■ Powering up AC-powered switch
■ Powering up DC-powered switch
■ Verifying messages on management terminal
■ Logging in to the system
■ Setting required country options
■ Changing craft password
■ Setting date and time
■ Setting system maintenance parameters
■ Saving translations
After the system is activated, the telephones and other equipment need to be
installed (see Chapter 9, "Install and Wire Telephones and Other Equipment").
The system is administered by adding the customer data to match the wiring,
telephones, and other equipment (see the reference to the book at the end of
Chapter 9, "Install and Wire Telephones and Other Equipment"). The telephones
and other equipment are tested (see Chapter 10, "Test Telephones and Other
Equipment").
!
CAUTION:
While performing these procedures, you may need to reseat circuit packs.
To prevent damage from static electricity, always wear an Electromagnetic
