A SERVICE OF

logo

Open as PDF
next previous
9033029 Installation 9
MMounting the Switch on a Wall
The module ships with one (1) velcro strip. The velcro strip is used to attach
the switch to the wall
.
Figure 2-1 illustrates two recommended orientations for wall mounting the
switch. This figure also shows where to the position velcro on the switch.
To attach velcro do the following:
1. Place the switch on a flat surface with the Cabletron logo on the left
and the 100Base-FX ports on the right.
2. Attach the velcro to the center of the switch using the
supplied 2 x 4 inch strip of velcro.
3. Position the switch on a wall surface that can safely support the
switch.
Figure 2-1. Mounting the Switch on a Wall
Do not attach rubber feet to the switch when mounting the switch to the
wall with velcro.
ELS100-8TXUF2.book Page 9 Friday, June 4, 1999 4:01 PM