31-7
Catalyst 2950 and Catalyst 2955 Switch Software Configuration Guide
78-11380-10
Chapter 31 Configuring EtherChannels
Configuring EtherChannels
Figure 31-3 Load Distribution and Forwarding Methods
Configuring EtherChannels
These sections describe how to configure EtherChannel interfaces:
• Default EtherChannel Configuration, page 31-8
• EtherChannel Configuration Guidelines, page 31-8
• Configuring Layer 2 EtherChannels, page 31-9
• Configuring EtherChannel Load Balancing, page 31-11
• Configuring the PAgP Learn Method and Priority, page 31-12
Note Make sure that the interfaces are correctly configured (see the “EtherChannel Configuration Guidelines”
section on page 31-8).
Note After you configure an EtherChannel, configuration changes applied to the port-channel interface apply
to all the physical interfaces assigned to the port-channel interface, and configuration changes applied
to the physical interface affect only the interface where you apply the configuration.
101239
Cisco router
with destination-based
forwarding enabled
EtherChannel
Switch with
source-based
forwarding enabled
