A SERVICE OF

logo

A-18
Cisco TelePresence System Release 1.4 Administrator’s Guide
OL-12586-02
Appendix A Command Line Interface (CLI) Commands
set network ip eth0
set network ip eth0
set network ip eth0 address
Syntax Description
Command Modes Admin
Command History
Usage Guidelines Use this command to define a new IP address and subnet mask for Ethernet 0. The system automatically
reboots after you execute this command.
Examples
admin:set network ip eth0 192.168.1.5 255.255.255.0
*** WARNING ***
This will cause the system to restart - Do you want to continue?
Enter “yes” to continue and restart or any other key to abort
yes
Related Commands
address Defines a new IP address and subnet mask for Ethernet 0. Values for address
are valid dotted decimal IP addresses followed by subnet mask value.
Release Modifications
1.1 This command was first documented.
Command Description
set network dns Defines new IP addresses for primary or secondary DNS servers